DIRECTIONS: 3 SPOUT BOTTLE FILLER


Establishing A Flow To The Reservoir Tank:

The source of wine needs to either have a siphon established to
the reservoir intake at the back of the 3 Spout Bottle Filler, or the

source of wine needs to be higher than the bottle filler.

Once you have flow wine established with the reservoir full, you
will need to prime the filler tube.


Priming The Filler Tubes:

- Take a wine bottle and fill it all the way to the top with
water. This will be used as the primer.

- Press down on one of the filler tubes and while depressed
slowly slide the bottle filled with water up on to the filler
tube as far as possible. This will expel all the air out of the
tubes.

- Leave the bottle in place and release the filler tube. Water is
now stored in the tube.

- Remove the bottle. The tube is now primed. You are now ready to
bottle.

- To prime the remaining 2 tubes repeat steps 1-4 again.


Save Time:
Super Fast Prime - Place a short piece of tubing over the tip of
the filler tube. Depress the tube and draw the liquid into the
filler tube.

Best Wishes,
Customer Service at E. C. Kraus

To receive our free winemaking newsletter! Click Here

E. C. Kraus

Home Wine & Beer Making Supplies

Address: 733 S. Northern Blvd. - P. O. Box 7850 - Independence, MO  64053

Phone:(816) 254-7448  Fax:(816) 254-7051  Toll Free: (800) 353-1906

Email: customerservice@eckraus.com

Copyright (c) 2003, Kraus Sales, L. L. C. All rights reserved. This article may be passed

along to friends and others, as long as it is used in its entirety. Distribution or publishing of

this article in partial or edited form is prohibited.